Advanced Maintenance Membership
For your comfort system, one of the most important steps you can take to prevent future problems and unwanted costs is bi-annual maintenance. When done properly, maintaining your system will save you money on energy bills and help your system last longer. Enjoy the peace of mind that comes with knowing your comfort system has been prepared for efficient operation by our certified technicians.
Benefits:
- Protect your home
- Improve efficiency
- Reduce heating & cooling cost
- Add years to your equipment life
- Priority service
- Discounts on repairs

Your Advanced Maintenance Agreement
Your agreement includes evaluation of the following:
- Thermostat Calibration & Operation
- Indoor Air Coil Condition
- Replace Air Filter
- Electric Heater Controls & Operation
- Relays & Indoor Unit Wiring
- Indoor Blower Motor
- System General Physical Condition
- Indoor Temperature Rise/Fall
- Outdoor Fan Blade Balance
- Outdoor Fan Motor
- Contactor Points
- Starting Components
- Outdoor Unit Wiring
- Compressor Amperage/Performance
- Refrigerant Charge
- Defrost Components
- Reversing Valve Operation
- Ductwork
AM benefits can often spot small problems before they become large. Should repairs be necessary at any time during your agreement, you will receive priority scheduling, a 20% discount on all repairs, and $100 off after-hours service fees.

Your Advanced Maintenance (AM) Agreement also includes:
Spring Cooling 21-Point Inspection
- Install gauges and check operating pressure
- Clean condenser coil with water
- Check & tighten all electrical connections
- Lubricate bearings & motors where applicable
- Inspect & clear condensate drain
- Cycle & check thermostat for accuracy
- Check & adjust fan belt where applicable
- Check voltage & amperage to condensing unit
- Clean or change up to 2 basic air filters per system*
*Additional charge for extra or specialty filters
Your Advanced Maintenance (AM) Agreement also includes:
Fall Heating 21-Point Inspection
- Inspect heat exchanger for cracks & soot
- Adjust flame for optimum efficiency
- Check fuel pipe & be sure of adequate draft
- Check & clean burners as necessary
- Check & clean pilot assembly
- Check fan control & limit operation
- Check & lubricate blower assembly as necessary
- Cycle & check thermostat for accuracy
- Clean or change up to 2 basic air filters per system*
*Additional charge for extra or specialty filters
