Advanced Maintenance Membership

maintenance.

For your comfort system, one of the most important steps you can take to prevent future problems and unwanted costs is bi-annual maintenance. When done properly, maintaining your system will save you money on energy bills and help your system last longer. Enjoy the peace of mind that comes with knowing your comfort system has been prepared for efficient operation by our certified technicians.

Benefits:

  • Protect Your Home
  • Improve Efficiency
  • Reduce Heating and Cooling Cost
  • Add Years to Your Equipment Life
  • Enjoy Priority Service
  • Receive Discounts on Repairs

Your Advanced Maintenance (AM) Agreement

Your agreement includes evaluation of the following:

  • Thermostat Calibration and Operation
  • Indoor Air Coil Condition
  • Replace Air Filter
  • Electric Heater Controls and Operation
  • Relays and Indoor Unit Wiring
  • Indoor Blower Motor
  • System General Physical Condition
  • Indoor Temperature Rise/Fall
  • Outdoor Fan Blade Balance
  • Outdoor Fan Motor
  • Contactor Points
  • Starting Components
  • Outdoor Unit Wiring
  • Compressor Amperage/Performance
  • Refrigerant Charge
  • Defrost Components
  • Reversing Valve Operation
  • Ductwork

AM can often spot small problems before they become large. Should repairs be necessary at any time during your agreement, you will receive priority scheduling, a 20 percent discount on all repairs, and $100 off after-hours service fees.

In Spring Your AM Agreement Also Includes:

Spring Cooling 21-Point Inspection

  • Install Gauges and Check Operating Pressure
  • Clean Condenser Coil with Water
  • Check and Tighten all Electrical Connections
  • Lubricate Bearings and Motors Where Applicable
  • Inspect and Clear Condensate Drain
  • Cycle and Check Thermostat for Accuracy
  • Check and Adjust Fan Belt Where Applicable
  • Check Voltage and Amperage to Condensing Unit
  • Clean or Change up to Two Basic Air Filters per System*

*Additional Charge for Extra or Specialty Filters

For Fall Your AM Agreement Also Includes:

Fall Heating 21-Point Inspection

  • Inspect Heat Exchanger for Cracks and Soot
  • Adjust Flame for Optimum Efficiency
  • Check Fuel Pipe and be Sure of Adequate Draft
  • Check and Clean Burners as Necessary
  • Check and Clean Pilot Assembly
  • Check Fan Control and Limit Operation
  • Check and Lubricate Blower Assembly as Necessary
  • Cycle and Check Thermostat for Accuracy
  • Clean or Change up to Two Basic Air Filters per System*

*Additional Charge for Extra or Specialty Filters

Need HVAC Service?

Contact the experts at Advanced Heating and Air Conditioning.

Call us at 763-330-0560!